Description
Need to remove an old PropOne coating to make way for a fresh, new application?
Use PropOne Paint Stripper and Silicone Remover to thoroughly remove old coatings on your propellers and running gear.
- Easy application – Brush on and it will do the rest!
- Reduce dust and noise – Easy removal
- Deep penetration performance allows multiple layers to be stripped
- Marine Grade: DCM & NMP free*
PropOne Silicone Remover is designed to remove PropOne Clear Coat. It can also be used as a general purpose silicone remover, to remove thin coatings.
PropOne Paint Stripper will remove paints, varnishes and lacquers. It is primarily to be used with PropOne Silicone Remover for removal of the PropOne™: Foul Release Coating primer coat.
Do not use on plastic surfaces or on resin impregnated wood fibreboard materials.
For plastics and other delicate surfaces test a small area first to ensure Silicone Remover & Paint Stripper do not affect the underlying substrate.
*Does not contain toxic Dichloromethane and N-Methylpyrrolldone
Coverage
|
|
Estimated Prop Wash Coverage Guide:
Propeller Size and Number of Blades
|
|
|
18″- 24″ |
24″- 36″ |
36″- 48″ |
|
|
Three or four blades |
Four or five blades |
Five blades |
| Running gear components to be cleaned |
One propeller |
250mL Prop Wash |
250mL Prop Wash |
250mL Prop Wash |
| Two propellers |
250mL Prop Wash |
250mL Prop Wash |
1 Litre Prop Wash |
Two propellers, two rudders
two propeller shaft struts |
250mL Prop Wash |
250mL Prop Wash |
1 Litre Prop Wash |
| Two propellers, two rudders, two propeller shaft struts & two trim tabs |
250mL Prop Wash |
1 Litre Prop Wash |
1 Litre Prop Wash |
PropOne Silicone Remover: 15 sqm per litre (3 sqm per 200mL)
PropOne Paint Stripper: 15 sqm per litre (3 sqm per 200mL)
Application
PropOne Chemical Removal System, i.e. Silicone Remover and Paint Stripper
Silicone Remover
- Remove all marine growth from surface.
- Apply Silicone Remover approx. 2mm thick using a brush. Tip: Prevent drying out by covering the treated area with cling-wrap in hot/windy climates.
- Do not allow remover to come in contact with water.
- Leave in contact for 2-3 hours or until softened.
- Remove with a stiff nylon or wire brush, scrubbing in a circular motion.
- Wipe off any remaining residue with a xylene or toluene-soaked cloth.
- If any coating remains after scraping, apply second coat.
- Once done, proceed with Paint Stripper
Paint Stripper
- Apply Paint Stripper approximately 2mm thick using a brush or roller
- Leave in contact for at least 15 minutes or until softened
- Scrape off coating with slight pressure and appropriately dispose of waste. A wire brush, strong scourer or paint scraping tool are recommended.
- If any coating remains after scraping, apply second coat.
- Wipe off any remaining residue with an acetone-soaked cloth, then hose-down surface to leave a bright metal surface.
PropOne Brief Application Guide
PropOne Chemical Removal Technical Data Sheet
